Custom Services
Metal Bar Gratings
Orsogril® Fencing
Fiberglass Gratings
Metal Safety Gratings
Perforated Metals
Expanded Metals
Wire Cloth
ACO Drain Systems
Stair Nosings and Treads
Algrip Safety Floor Plates
Architectural Grilles
Handrail Components
Construction Castings
METAL SAFETY GRATINGS
Grip Strut® 8 & 10 Diamond Load Tables
As width increases, grating strut flexure becomes much more important. Eight and 10-Diamond products are wide enough to require a change in the assumptions used to prepare the 2-through 5-Diamond Product Selection/Design Tables. No longer will it be assumed that both side channels are equally effective in supporting a concentrated load. In fact, to provide a high level of safety, one side channel will be required to carry 100% of a concentrated load.Also strut deflection for 8- and 10-Diamond products may be significant. The most critical case occurs when a concentrated load is located at mid-span and mid-width. To determine how the struts perform under this loading, 3-ft. long samples of each material and thickness were tested. For these tests the side channels were continuously supported and loads were applied using a 1-ft. long and 1-in. wide bar placed parallel to the side channels at mid-width and at the longitudinal center.
Results of these tests, included in the 8- and 10-Diamond Product Design Tables, proved the performance of these materials when a concentrated load is applied at mid-span and mid-width. If a concentrated load is to be applied at mid-width at the end of a plank, consult the strut loading table.
The following values have been tabulated for 8- and 10-Diamond grating:
Allowable Uniform Load (U) - Values are given in the rows labeled "U" and are the lowest of the (1) maximum allowable uniform loads considering channel flexure, and (2) maximum grating surface flexure.
Deflection Corresponding to "U" - Deflection values appear in the rows labeled "D", below the "U" values, and are maximum deflections the allowable uniform loads would produce. Maximum deflections will occur at mid-span and mid-width and will be the sum of side channel and grating surface deflections. (Fig. 3).
Allowable Concentrated Load (C) - Values tabulated in the rows labeled "C", are the lowest of the (1) maximum allowable concentrated load considering side channel flexure (with one side channel supporting the entire load-Fig. 2), and (2) the maximum allowable strut flexure (Fig. 1).
Deflection Corresponding to "C" - Deflection values are indicated below the "C" values in the table and are deflections the allowable concentrated loads will produce at mid-span and at mid-width. The deflection is the sum of side channel and grating surface deflections.
Allowable loads and deflections: U - uniform load (lb./ft.), C - Concentrated load (lb.), Cs - Allowable concentrated load per foot of length at mid-width (lb./ft.), D - Deflection (in.). Spans to the left of heavy line produce a deflection of 1/4" or less under a uniform load of 100 lbs. per square foot.
Printer Friendly Version
8-Diamond Plank Load Table - 18-3/4" Width
10-Diamond Plank Load Table - 24" Width
Printer Friendly Version
